Fujitsu S1500M - ScanSnap - Document Scanner Operator's Manual page 318

Symptom
Paper is not fed. It
stops midway.
The ScanSnap is not
recognized even if
ScanSnap Manager
is installed.
The file size of a
scanned black &
white image is the
same as that of a
scanned color
document image.
Color documents are
not scanned as color.
Check This Item
Is the pick roller dirty?
Is the pick roller worn out?
Are there any debris on the
document feeding path?
Do the loaded documents (e.g.
business cards or postcards)
satisfy the required size
conditions?
If not, they might not pass
smoothly through the ADF.
Are you scanning documents
with a different [Paper size]
setting?
Did you load any paper that is
thin, torn, or bent?
Did you connect the ScanSnap
to your computer before
installing ScanSnap Manager?
Is the ScanSnap registered as
[Other Device] or [Unknown
Device] in [Device Manager]?
Is the black & white document
scanned in color or gray mode?
Documents in a dark color close
to black, such as dark green,
may be scanned as black and
white or gray.
318
Troubleshooting Checklist
Resolution
Clean the pick roller.
For details about how to clean the pick roller,
refer to "Cleaning the Inside of the
ScanSnap" (page 327).
Replace the pick roller.
For details about how to replace the pick
roller, refer to "Replacing the Pick Roller"
(page 339).
Remove any debris from the document
feeding path.
For details about how to resolve such a
problem, refer to "Clearing Document Jams"
(page 302).
Try the following:
•
Slightly push through with your finger the
first sheet of the documents at the start of
scanning.
•
Change the insertion direction of the doc-
ument.
Select the [Paper] tab → [Paper size] on the
ScanSnap setup dialog box/window, and
specify the correct paper size for scanning.
When scanning a document that is hard to
feed, load it sheet by sheet or use the Carrier
Sheet.
Select the [Start] menu → [Control Panel] →
[System and Maintenance] → [Device
Manager].
Delete the device name such as USB device
(which differs depending on the operating
system) under [Other Device] selection in the
[Device Manager], and restart your
computer.
Select the [Scanning] tab from the ScanSnap
setup dialog box/window and change the
setting for [Color mode] to [B&W].
Select the [Scanning] tab from the ScanSnap
setup dialog box/window and change the
setting for [Color mode] to [Color].