Fujitsu S1500M - ScanSnap - Document Scanner Operator's Manual page 163

•
Place all documents under the pick roller (center).
Documents that are not under the pick roller cannot be fed.
•
Adjust the side guides to the widest document to be scanned.
•
For smaller documents which cannot contact the side guide, carefully load them straight
into the ADF paper chute (cover). If the documents are skewed during a scan, the qual-
ity of scanned image data may be degraded (partly lost image data/slant lines produced)
or scanned image data may be output in different size from the original. If you have diffi-
culties in feeding documents straight, it is recommended to scan documents in several
batches and enable continuous scanning; scan documents of about the same width in
one batch.
Note that smaller documents that cannot be guided by the side guide may cause a jam.
6.
Press the [Scan] button on the ScanSnap.
⇒
The size of all output image data conforms to the respective documents.
If a document is scanned at an angle, an image may be output that does not match the
document size.
Using the ScanSnap in Various Ways (for Windows Users)
163
Width of the pick roller