Fujitsu S1500M - ScanSnap - Document Scanner Operator's Manual page 313

Symptom
Scanning does not
start.
Check This Item
Is ScanSnap Manager supplied
with your ScanSnap installed in
your computer?
Does the [Scan] button blink
continuously?
Is the USB cable connected
correctly?
Is ScanSnap Manager started?
If ScanSnap Manager is started
up successfully, the [ScanSnap
Manager] icon appears on
the taskbar.
If ScanSnap Manager is started
up successfully, the [ScanSnap
Manager] icon appears in
the Dock.
313
Troubleshooting Checklist
Resolution
Install ScanSnap Manager.
For details about how to install the software,
refer to "Getting Started".
Disconnect and then re-connect the power
cable.
Wait at least 5 seconds before reconnecting
the power cable.
Check the USB cables are connected
correctly.
When using a USB hub, check the hub's
power supply.
If a USB hub is used, it should be a powered
hub equipped with an AC adapter. If you
connect to a non-powered hub, the
ScanSnap may not work properly.
If ScanSnap Manager is not started, do the
following:
From the [Start] menu, select [All Programs]
→ [ScanSnap Manager] → [ScanSnap
Manager] to start up ScanSnap Manager.
From Finder, select [Applications] →
[ScanSnap] → [ScanSnap Manager] to start
up ScanSnap Manager.