Table of Contents
Advertisement
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are
not breakdowns sometimes. Please confirm again before sending it to repair. If there are real
breakdowns, please come to the special maintenance department or after-sale service department of
our company. Do not repair it by yourself.
Phenomenan
The digitron displays E0.
The drainage cannot work,
or is too slow.
The digitron displays E1.
It stops running in midway.
The digitron displays E2.
The safety switch acts,
and the spinning cannot
work. The digitron
displays E3.
The water filling does
not work, or is slow. After
stated time later,
the digital displays E4.
The digitron displays E6.
Not wash
The machine
does not act
Not spin
There's abnormal sound
inside the machine
The water tap leaks
Common phenomena
Phenomena
The spinning is intermittent when it starts.
The wash procedure pauses.
Select spin program, but it does
not work.
There may be some water
flowing out of the drain hose in
the first use of the machine.
The reason
Is the drain hose
blocked?
The top lid is opened
during reserve procedure.
The top lid is not closed.
Are the laundries put
slantingly?
Is the machine slanting?
Is the water tap opened, or
is there water supply failure?
Is the water inlet valve
blocked?
Is the water pressure too
low?
The water level sensor is
bad.
Is there power failure?
Is the power plug inserted
tightly?
Is the water level reached
preset position?
Is the power plug inserted
tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly
in spinning?
Are there any foreign materials?
Is the screw of the jointer of
water inlet hose loose or awry?
Explanation
Balance the laundries to avoid slanting.
The cloth sensor is detecting , it will add
water after about 48 seconds.
The program is setting the drain time , certain
period is needed before it starts spinning.
It is the water remained performance
inspection by the factory.
14
How to settle
Close the top lid.
Clean the foreign material. Open
and close the top Lid Once.
Close the top lid.
Reorder the laundries.
Close the top lid.
Open and close the top lid after
being placed horizontally.
Open the water tap,then open
and close the top lid once.
Clean the water inlet valve,
then open and close the top
lid once.
Use after water pressure is
normall.
Please contact the after-sales
service department.
Please use it when there's
power supply.
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug
tightly.
Close the top lid.
Set the laundries flat.
Adjust the machine to be even
Reorder the laundries and
close the top lid.
Remove the foreign materials.
Fasten the screw of the
jointer properly.
Advertisement
Table of Contents
