Table of Contents
Advertisement
Installation and adjustment
Please install and adjust the machine according to the requirement of
the manual. It is very important to your security and correct
operating the machine.
Install the lint filter
After opening the package, please take out the lint
filter from the document bag, install it to the inner
tub. See to the figure.
Install the bottom plate
After you open the package, please lean
the washing machine gently down on Soft
object ( like the towel cloth,blanket, etc. ).
Install the bottom plate to the bottom of the
machine with the eight screws by a cross
screwdriver, then lift the machine up gently.
See to the figure:
Adjust the Installation position
The largest allowable slope of the shank base of the machine is 2 .The
slanting or rough ground will result in unstable running or stoppage of the
machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
1 .To twist the adjustable leg, please first
lift up the side of the leg slightly, loosen
the adjustable nut, and twist the leg.
2 . After adjustment, fasten the nut.
Drain hose
Ensure the drain hose si mounted at a suitable height.
(
Between 800-1200mm
Do not poke it too far down the drain pipe or silphoning will occur.
above the floor).
4
Inner tub
Bottom plate
2
Fasten
Loosen
High
Low
Lint filter
Front
Back
Soft object
Screw
the adjustable nut
the adjustable
feet
Advertisement
Table of Contents
