Alert Messages (Displayed On The Control Panel) - Ricoh Aficio SP C830DN User Manual

3. Troubleshooting
Message
"Waitg. for prt.data"

Alert Messages (Displayed on the Control Panel)

• Before turning the main power switch off, see p.27 "Turning On/Off the Power".
Message
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
"Hardware Problem:
Ethernet"
"Hardware Problem: HDD"
92
The printer is waiting for the next data to print. Wait a while.
Cause
• The wireless LAN
board was not inserted
when the printer was
turned on.
• The wireless LAN
board was pulled out
after the printer was
turned on.
• The settings are not
updated although the
unit is detected.
An error has occurred in the
Ethernet interface.
An error has occurred in the
hard disk.
Status
Solution
• Turn off the main power switch,
and then confirm the wireless LAN
board is inserted correctly. For
details about installing the board,
see "Installing the Interface Units",
Operating Instructions.
• If the message appears again,
contact your service
representative.
Turn the main power switch off and
then back on again. If the message
appears again, contact your service
representative.
• Turn the main power switch off
and then back on again. If the
message appears again, contact
your service representative.
• The hard disk may have not been
installed properly if you have
installed it yourself. Check that it is
properly installed For details
about installing the unit, see
"Installing the Memory Expansion
Units", Operating Instructions.