Schedule; Off - Panasonic PT-DW530E Operating Instructions Manual

NO SIGNAL SHUT-OFF
J
If no signal is input within a preset time, the projector
power is automatically switched to the standby state.
1. Select [NO SIGNAL SHUT-OFF] in Step
3.
2. Press ◄► to switch [NO SIGNAL
SHUT-OFF] setting.
The NO SIGNAL SHUT-OFF is
DISABLE
ineffective.
The Auto Power-Off time can be
10 to 90 minutes
set in 10 minute increments.
STANDBY MODE
J
This function can set the electric power when the
projector is standing by.
1 ) Select [STANDBY MODE] in Step 3.
2 ) Press ◄► to switch [STANDBY MODE]
setting.
The setting will change as follows each time the
z
button is pressed.
NORMAL
Note
If STANDBY MODE is set to [ECO], you cannot use
z
network functions when the projector is standing by. Also,
you cannot use some RS-232C protocol commands.
When you turn the POWER switch [ON], display of
the initial image may be delayed for approximately
10 seconds when compared with [NORMAL] mode
operation.
If set to [NORMAL], you can use network functions when
z
the projector is standing by.

SCHEDULE

This sets the command execution schedule for each
day of the week.
How to enable the SCHEDULE
J
function
1 ) Press ▲▼ to select [SCHEDULE].
2 ) Press ◄► to switch [SCHEDULE].
The setting will change as follows each time
z
◄► is pressed.
Note
If [SCHEDULE] is set to [ON], the setting for [STANDBY
z
MODE] is automatically set to [NORMAL] and cannot be
changed. Even if [SCHEDULE] is then set to [OFF] when
in this state, the setting of [STANDBY MODE] remains at
[NORMAL].
How to assign a program
J
1 ) With [SCHEDULE] switched to [ON],
press <ENTER> button.
The [SCHEDULE] screen will be displayed.
ECO z
2 ) Select and assign program to each day
of week.
Press ▲▼ to select a day of week and press
z
◄► to select a program number.
You can set the program from No.1 to No.7.
z
"- - -" indicates that the program number has
not been set yet.
How to set a program
J
You can set up to 16 commands to each program.
1 ) On the [SCHEDULE] screen, press ▲▼
to select [PROGRAM EDIT].
2 ) Press ◄► to select a program number
to be set and press <ENTER> button.
3 ) Press ▲▼ to select a command
number and press <ENTER> button.
You can change the page using ◄►.
z
PROJECTOR SETUP menu
ON

OFF

65
ENGLISH -