Table of Contents
Advertisement
2.8.3.
Device.fan
The system comes with two 28 mm * 40 mm (15500 rpm) device fans.
Refer to the illustration below for location of the device fans.
To uninstall the device fan:
1.
Disconnect the device fan
cable from the connector on the
motherboard or backplane board.
2.
Lift the fan, then set aside.
To reinstall the device fan:
1.
Insert the fan to the fan cage. The
airflow directional arrow on the fan
side should point towards the rear
panel.
2.
Connect the device fan cable to
the fan connector on the backplane
board or on the motherboard.
2-22
28 mm * 40 mm device fans
Chapter 2: Hardware setup
Advertisement
Table of Contents
