Air Oasis Induct 9 Owner’s Owner's Manual

Air Oasis Induct 9 Owner’s Owner's Manual

Advertisement

Quick Links

Troubleshooting Guide

Problem
Unit does not turn on.
1. Power Cord
2. AHPCO™ Cell
3. Indicator Light Not
Working
3401 Airway Blvd
Amarillo, TX 79118
Toll-Free: 1-800-936-1764 Fax: 1-806-373-7799
www.AirOasis.com
Copyright© 2006 Air Oasis All Rights Reserved
Reason
Solution
1. Check to make sure
power cord is plugged
in or properly connect-
ed to HVAC unit.
2.
Check
sure UV lamp within
AHPCO™
plugged in completely.
3. Make sure exposed
end of black fiber optic
cord is exposed to the
UV light.
to
make
Cell
in
Induct 9
Owner's
Manual
This Manual Includes:
• Warranty
• Safety Warnings
• Installation Instructions
• Operating Instructions
• Replacement Directions
• Troubleshooting Tips
Before operating this unit or replacing the AHPCO™
Cell carefully read the contents of this manual.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Induct 9 Owner’s and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Air Oasis Induct 9 Owner’s

  • Page 1 • Replacement Directions • Troubleshooting Tips 3401 Airway Blvd Amarillo, TX 79118 Before operating this unit or replacing the AHPCO™ Cell carefully read the contents of this manual. Toll-Free: 1-800-936-1764 Fax: 1-806-373-7799 www.AirOasis.com Copyright© 2006 Air Oasis All Rights Reserved...
  • Page 2 Your ing the AHPCO Cell in place. Then Air Oasis™ Induct ACT™ air purifier has been designed to destroy these invisible slide the AHPCO Cell up and out of pollutants and provide your home or place of work with the luxury of clean air.
  • Page 3 Induct 9 Installation Instructions Step 1 Tear out the cutout template and trace the rectangle onto the ductwork. Step 2 Drill holes at each corner of the rectangle. trace the rectangle onto the ductwork.
  • Page 4 If you do not have a hole saw tear this page off and cut the circle out. Then place on the ductwork in desired position and trace the rectangle. Drill holes as indicated and then use a jig saw or metal cutting snips to cut out the circle. Step 3 Insert unit into pre-cut hole.
  • Page 5 • Do not use with damaged cord or plug. If appliance is not working as it should, CAUTION: Before attempting to service the Air Oasis unit, be sure the has been dropped, damaged, left outdoors, or dropped into water, call customer power is off and unplugged.
  • Page 6 Maintenance and Customer Service If you require any additional information or have problems with your Air Oasis ap- Air Oasis gives you the following limited warranty for this product only if it was origi- pliance, you may call Air Oasis customer service at:...

This manual is also suitable for:

Induct 9

Table of Contents