Table of Contents
Advertisement
Quick Links
Troubleshooting Guide
Problem
Unit does not turn on.
1. Power Cord
2. Switch
3. AHPCO™ Cell
Unit is not reducing
1. Defective AHPCO™
odors.
Cell
3401 Airway Blvd
Amarillo, TX 79118
Toll-Free: 1-800-936-1764 Fax: 1-806-373-7799
www.AirOasis.com
Copyright© 2006 Air Oasis All Rights Reserved
Reason
Solution
1. Check to make sure
power cord is plugged
in.
2. Check to make sure
switch is in the on posi-
tion.
3.
Check
sure UV lamp within
AHPCO™
plugged in completely.
1. Check to make sure
the AHPCO™ Cell has
a blue glow. If you see
no glow or the glow has
turned to a purple color,
contact Air Oasis.
to
make
Cell
in
Induct 9
Owner's
Manual
This Manual Includes:
• Warranty
• Safety Warnings
• Installation Instructions
• Operating Instructions
• Replacement Directions
• Troubleshooting Tips
Before operating this unit or replacing the AHPCO™
Cell carefully read the contents of this manual.
Advertisement
Table of Contents
Related Manuals for Air Oasis Air Purifier Induct 9
Summary of Contents for Air Oasis Air Purifier Induct 9
- Page 1 Cell 3401 Airway Blvd Amarillo, TX 79118 Toll-Free: 1-800-936-1764 Fax: 1-806-373-7799 www.AirOasis.com Copyright© 2006 Air Oasis All Rights Reserved Solution 1. Check to make sure power cord is plugged 2. Check to make sure switch is in the on posi- tion.
-
Page 2: Important Safety Instructions
Important Safety Instructions When operating electrical appliances, basic precautions should always be fol- lowed. WARNING To reduce the risk of fire, electric shock or injury: • Do not use outdoors or on wet surfaces. • Use only as described in this manual. •... - Page 3 Induct 9 Installation Instructions Step 1 Tear out the cutout template and trace the circle onto the ductwork and cut hole . Step 2 Remove wax paper from the gasket.
- Page 4 Step 3 Insert unit into pre-cut hole. If you do not have a hole saw tear this page off and cut the circle out. Then place on the ductwork in desired position and trace the rectangle. Drill holes as indicated and then use a jig saw or metal cutting snips to cut out the circle.
- Page 5 AHPCO Cell is working properly. AHPCO™ Cell Replacement Step 1 CAUTION: Before attempting to service the Air Oasis unit, be sure the power is off and unplugged. Remove three (3) screws at the top of the aluminum face plate.
- Page 6 Air Oasis gives you the following limited warranty for this product only if it was origi- nally purchased for residential or commercial use but, not resale from Air Oasis or an Air Oasis Authorized Retail Dealer. Air Oasis will repair or replace, free of charge, to the original purchaser, any part that is found to be defective in material or workmanship within three (3) years of the date of purchase.
Need help?
Do you have a question about the Air Purifier Induct 9 and is the answer not in the manual?
Questions and answers