Download Print this page

Air Oasis Dual Induct (120v) Owner's Manual

Air oasis dual induct (120v) owner's manual

Advertisement

Quick Links

Troubleshooting Guide
Problem
Unit does not turn on.
1. Power Cord
2. AHPCO™ Cell
3. Indicator Light Not
Working
3401 Airway Blvd
Amarillo, TX 79118
Toll-Free: 1-800-936-1764 Fax: 1-806-373-7799
www.AirOasis.com
Copyright© 2006 Air Oasis All Rights Reserved
Reason
Solution
1. Check to make sure
power cord is plugged
in or properly connect-
ed to HVAC unit.
2.
Check
sure UV lamp within
AHPCO™
plugged in completely.
3. Make sure exposed
end of black fiber optic
cord is exposed to the
UV light.
to
make
Cell
in
Dual Induct
(120v)
Owner's
Manual
Before operating this unit or replacing the AHPCO™
Cell carefully read the contents of this manual.
This Manual Includes:
• Warranty
• Safety Warnings
• Installation Instructions
• Operating Instructions
• Replacement Directions
• Troubleshooting Tips

Advertisement

loading
Need help?

Need help?

Do you have a question about the Dual Induct (120v) and is the answer not in the manual?

Questions and answers

Summary of Contents for Air Oasis Dual Induct (120v)

  • Page 1 3. Indicator Light Not Working 3401 Airway Blvd Amarillo, TX 79118 Toll-Free: 1-800-936-1764 Fax: 1-806-373-7799 www.AirOasis.com Copyright© 2006 Air Oasis All Rights Reserved Solution 1. Check to make sure power cord is plugged in or properly connect- ed to HVAC unit.
  • Page 2: Important Safety Instructions

    Important Safety Instructions When operating electrical appliances, basic precautions should always be fol- lowed. WARNING To reduce the risk of fire, electric shock or injury: • Do not use outdoors or on wet surfaces. • Use only as described in this manual. •...
  • Page 3 Dual Induct Installation Instructions Step 1 Tear out the cut- out template and trace the rectangle onto the ductwork. Step 3 Cut the rectan- gle out of the ductwork with a jig saw or a pair of metal cutting snips. Step 2 Drill holes...
  • Page 4 Step 4 Remove the wax paper from the gasket. Step 6 Drill the metal tapping screws in to hold unit in place. Tear this page off and cut the rectangle out. Then place on the duct work in desired position and trace the rect- angle.
  • Page 5 AHPCO Cell is working properly. AHPCO™ Cell Replacement Step 1 CAUTION: Before attempting to service the Air Oasis unit, be sure the power is off and unplugged. Remove three (3) screws at the top of the aluminum face plate.
  • Page 6: Warranty

    Warranty Air Oasis gives you the following limited warranty for this product only if it was origi- nally purchased for residential or commercial use but, not resale from Air Oasis or an Air Oasis Authorized Retail Dealer. Air Oasis will repair or replace, free of charge, to the original purchaser, any part that is found to be defective in material or workmanship within three (3) years of the date of purchase.

This manual is also suitable for:

Dual induct