Do you have a question about the iAdaptAir S and is the answer not in the manual?
Questions and answers
Ani Duncan
June 6, 2025
Hi, I have the original air oasis small idaptair. The replacement filter light continues to stay lit after I have replaced the filter. Also, the air quality display orange light is always on. Does that mean the filter is not working.
Your help is appreciated.
Thank you, Ani
1 comments:
Mr. Anderson
August 15, 2025
If the replacement filter light stays lit after replacing the filter, it means the reminder has not been reset. Press and hold the button for three seconds to reset it.
If the air quality display shows an orange light, it indicates moderate air quality.
Page 1
For use with iAdaptAir™ S, M, L Models For safety and to ensure proper use carefully read the contents of this manual before operating or installing the unit.
Before operating the iAdaptAir™, please read this manual in its entirety. Doing so will give you important information to keep you safe from harm and ensure you get the most benefits from your device. For additional information please contact us: Mail: Air Oasis, LLC web: www.airoasis.com Attn: Customer Service e-mail: feedback@airoasis.com 3401 Airway Blvd.
Warranty Card. If you purchase this product from any source other than Air Oasis or an Air Oasis dealer, your purchase is “AS IS”, which means Air Oasis grants you no warranty, and that you, not Air Oasis, assume the entire risk of the quality and performance of this product, including the entire cost of any necessary servicing or repairs of any defects.
Important Safety Instructions When operating any electrical appliance, basic precautions should always be followed for safety. WARNING: To reduce the risk of fire, electric shock or injury: • Carefully read the entire contents of this manual. • Do not use outdoors or on wet surfaces. •...
Base Installation 1. Using the four included screws, attach the base. This will prevent injuries by ensuring the unit is stable and will not fall over.
Operation Control Panel • Feather touch controls are operated with a light touch of the finger. • The backlit controls allow for easy operation even in dark conditions. 1. After connecting the power supply, you will hear one beep and the control panel will illuminate for two seconds before entering standby mode.
Once the light is red, the filter is nearing the end of its’ lifespan and should be replaced soon. Once the filter is replaced, press the button for three seconds to reset the reminder. Additional controls can be found in the Air Oasis phone app. ®...
Page 8
4. After your account has been created, you will receive an email. Press the “Activate” button to activate your account. 5. Adding a new place Press Click on the camera +NEW PLACE icon to take a photo of the room or place where you will be using the air purifier.
Page 9
6. Adding a new device - Part 2 Press ADD to add Device is connect- After pressing OK You can now new device. ing to router. setup is complete. control your new device.
Maintenance Dust Guard Maintenance Ensure the iAdaptAir™ is disconnected from its’ power source before performing any maintenance. • Pivot the dust guard outwards and lift up to remove it from the air purifier. • Use a vacuum to remove any debris. Wipe down the dust guard with a damp rag.
Page 11
• Bi-Polar Ion Brushes: Using a pipe cleaner or a 0.2” or less diameter dowel rod to insert in to the 2 holes in front of the brushes to knock off any debris buildup. Clean the brush heads periodically for optimal effectiveness. •...
Filter Replacement When the filter replacement reminder turns red, the filter is nearing the end of its’ useful lifespan & needs to be replaced soon. 1. Open the filter cover by sliding it to the right. 2. Take out the old filter & replace with a new filter...
Page 13
3. Close the filter cover. 4. Press and hold the “Filter Replacement Reminder” for 3 seconds to reset it.
UV Lamp Replacement Ensure the iAdaptAir™ is disconnected from its’ power source before performing any maintenance. UV Lamp may be hot. Allow time for the lamp to cool before removing it. 1. Remove the filter cartridge. (See instructions on pg. 9) 2.
Troubleshooting Guide Malfunction Checked Items Solving Measures Is the power switched on? Press the power button The Machine is Is the power adapter loose Connect or change the power adapter Not Working or broken? The filter cartridge has too Replace the filter cartridge Odors from the much debris.
Need help?
Do you have a question about the iAdaptAir S and is the answer not in the manual?
Questions and answers
Hi, I have the original air oasis small idaptair. The replacement filter light continues to stay lit after I have replaced the filter. Also, the air quality display orange light is always on. Does that mean the filter is not working. Your help is appreciated. Thank you, Ani
If the replacement filter light stays lit after replacing the filter, it means the reminder has not been reset. Press and hold the button for three seconds to reset it.
If the air quality display shows an orange light, it indicates moderate air quality.
This answer is automatically generated