Page 4
Carefully read the entire contents of this manual. Do not use outdoors or on wet surfaces. Do not use the purifier in areas of extreme heat or in the presence of flamma- ble gas Do not handle the wires or appliance with wet hands. Do not use damaged or uninsulated wires.
Page 5
Using the four included screws, attach the base. This will prevent injuries by ensuring the unit is stable and will not fall over.
Page 6
After connecting the power supply, you will hear one beep and the control panel will illuminate for two seconds before entering standby mode. Power Button: 1st press turns on the purifier, ionizer, UV light and low fan speed. 2nd press turns off the ionizer. 3rd press turns off the UV light.
Page 7
Viewing Wifi Stauts Press the Smart Mode button once while the purifier is in standby (power cord plugged in to the purifier, but not powered on). The smiley faces will show the status of the WiFi connection: Green Flashing Happy Face = Not Connected Solid Green Happy Face = Connected...
Page 8
Dust Guard Maintenance Ensure the iAdaptAir is unplugged from its power source before ® performing any maintenance. Pivot the dust guard outwards and lift up to remove it from the purifier. Use a vacuum to remove any debris. Wipe down the dust gaurd with a damp rag.
Page 9
Clean the bi-polar brush heads periodically for optimal effectiveness. Use a pipe cleaner or something similar to insert into the two holes in front of the brushes to knock off any debris buildup. Use a soft cloth to clean the exterior surfaces (do not use chemicals or alcohol).
Page 10
When to Change Your Filter Your filter is brand new! Your filter has been Your filter is getting close Change your filter soon. No change needed used some. You still to a change. You still Only 25% filter life is soon.
Page 11
Close the filter cover. Power the iAdaptAir back on. Press and hold the Filter Replacement ® Reminder for 3 seconds to reset it.
Page 12
For optimal performance and maximum efficiency of your iAdaptAir , ensure all ® UV lamps are replaced annually. Ensure the iAdaptAir is unplugged from its power source before ® performing any maintenance. UV lamp may be hot. Allow time for the lamp to cool before removing it.
Page 13
Purifier Not Turning On Ensure the following: The power button has been pressed. The power cord is not loose or broken. The correct plug connector is in use. Your iAdaptAir® comes with international plugs. Ensure you are using the correct one for your country.
Page 14
iAdaptAir-S iAdaptAir-M iAdaptAir-L Warranty Lifetime Warranty Lifetime Warranty Lifetime Warranty Voltage 100-240VAC 100-240VAC 100-240VAC Rated Power 8 WATTS 24 WATTS 32 WATTS Dimensions 5.4in x 8.5in x 9.7in 11.2in x 11.2in x 28.3in 11.2in x 11.2in x 37in Weight 7 lbs. 15.5 lbs.
Need help?
Do you have a question about the iAdapt Air S and is the answer not in the manual?
Questions and answers