Page 1
Due to continuous improvements, the picture included within this owner’s manual may differ slightly from the actual product. Before operating this purifier, carefully read the contents of this manual.
Page 4
Carefully read the entire contents of this manual. Do not use outdoors or on wet surfaces. Do not use the purifier in areas of extreme heat or in the presence of flamma- ble gas Do not handle the wires or appliance with wet hands. Do not use damaged or uninsulated wires.
Page 5
For best results, the purifier should be placed in a central location three feet or higher from the ground. Remove the purifier from packaging, place in desired location, plug it in and flip the switch to the on position. The purifier can run 24/7. Base and Honeycomb - We recommend wiping with a dry towel to remove dust and buildup.
Page 6
WARNING OPTICAL RADIATION EXPOSURE HAZARD DO NOT ATTEMPT TO OPERATE UNIT WITHOUT ALLUMINUM SHELL COVERING AHPCO CELL. DO NOT ATTEMPT TO REPLACE AHPCO CELL WITHOUT DISCONNECTING POWER. PERMANENT EYE AND SKIN DAMAGE MA Y RESULT.
Page 7
Connect the lamp connector securely onto the AHPCO cell and use a Phillips head screwdriver to tighten the screws to secure the AHPCO cell. Slide the reset switch. Your purifier will beep in 2 years when it is time to replace the cell. Older models may have a reset button instead of a switch.
Page 8
Purifier Not Turning On Ensure the following: The power supply is plugged in. The power switch is in the on position. The UV lamp is plugged in completely. Beeping The AHPCO cell has expired. Replace the AHPCO cell (see pages 4-5). Poor Performance Debris buildup inside the purifier is inhibiting performance.
Need help?
Do you have a question about the Ionic Air and is the answer not in the manual?
Questions and answers