Table of Contents
Advertisement
2-36
21. Registering the Job Program
The present setting state can be registered in up to 3 program registration locations (1J, 2J
and 3J).
Press the Memory Input Key in the Setting mode. 1J starts blinking.
1
To change the program registration location, press the Multi-Print Key. The display is
switched in order of 1J → 2J → 3J →1J.
Select the program registration location (1J, 2J or 3J), and press the Memory Input Key
2
again.
When all LEDs on the control panel light up and then the normal display is resumed,
3
the program registration is over.
The program can be registered up to 3 programs for the Printer connection and up to 3 programs
for the PC connection.
Memory Input Key
Advertisement
Table of Contents
