What To Do If; Remedying Small Malfunctions - Electrolux ESL 6251 User Information

What to do if...

Remedying small malfunc-
tions
If the acoustic signal is activated, warning tones
sound if there are faults.
If one of the following fault codes is displayed in the
multi-display during operation:
– Fault codeÅ 10 (Problems with water inlet),
– Fault codeÅ 20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the
cycle that has started. The cycle will continue.
With other fault codes ("Å " followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact your lo-
cal Service Force Centre and inform them of the fault
code.
Malfunction
1 short warning tone, continu-
ously repeated, can be heard,
the cycle indicator for the selected
wash program is flashing:
the control indicator
up:
fault code Å 10 is displayed in the
multi-display:
(Problems with water inlet)
2 short warning tones, continu-
ously repeated, can be heard,
the cycle indicator for the selected
dishwashing cycle is flashing,
fault code Å 20 is displayed in the
multi-display. (Problems with wa-
ter outflow)
3 short warning tones, continu-
ously repeated, can be heard,
Fault code Å 30 is displayed in
the multi-display.
26
Possible cause
Water tap is blocked with limescale
or is faulty.
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the tap is
blocked.
lights
Filters in the base of the washing
compartment are blocked.
Water supply hose has not been
correctly positioned.
The sink outlet is blocked.
Water drain hose has not been cor-
rectly positioned.
The anti-flood system has been
triggered.
Remedy
Check the tap and have it repaired, if
necessary.
Turn on the tap.
Clean the filter in the threaded hose
fitting.
Cancel the dishwashing cycle (see
chapter: Starting a dishwashing cy-
cle),
clean filters (see chapter: Cleaning
the filters),
then start the dishwashing cycle
again.
Check the position of the hose.
Clean the siphon.
Check the position of the hose.
First shut off the water tap, then
switch off the appliance and contact
the Customer Care Department.