Front Panel Header - Gigabyte GA-6UASV3 User Manual

13) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status
indicator on the chassis to this header according to the pin assignments below. Note the positive and
negative pins before connecting the cables.
The front panel design may differ by chassis. A front panel module mainly consists of power
switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your
chassis front panel module to this header, make sure the wire assignments and the pin assign-
ments are matched correctly.
Hardware Installation
Pin No. Signal Name
1 PWLED+
2 5VSB
3 NC
4 ID_LED+
5 PWLED-
6 ID_LED-
7 HD+
8 F_SYSRDY
9 HD-
10 SYS_STATUS-
11 PWB+
12 L1_ACT
13 PWB+_GND
14 L1_LINK-
15 RST_BTN-
16 SENSOR_SDA
17 RST_BTN_GND
18 SENSOR_SCL
19 ID_SW+
20 CASE_OPEN-
21 ID_SW_GND
22 L2_ACT
23 NMI_SW-
24 L2_LINK-
12 24
Definition
Power LED Signal anode (+)
5V Stanndby Power
No Connect
No Connect
Power LED Signal cathode(-)
No Connect
Hard Disk LED Signal anode (+)
System Front board LED Signal
Hard Disk LED Signal cathode(-)
System Status LED Signal cathode(-)
Power Button Signal anode (+)
LAN1 active LED Signal
Ground
LAN1 Link LED Signal cathode(-)
Reset button Signal cathode(-)
SMBus Data Signal
Ground
SMBus Clock Signal
No Connect
No Connect
Ground
LAN2 active LED Signal
NMI switch Signal cathode(-)
LAN2 Link LED Signal cathode(-)
- 21 -
1 2