Configuring Marvell 88Se9182 Sata Controller - Gigabyte G1.Guerrilla User Manual

5-1-3 Configuring Marvell 88SE9182 SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. The Marvell 88SE9182 SATA controller controls the onboard GSATA3_6 and
GSATA3_7 connectors. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller and RAID mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to Inte-
grated Peripherals. To enable RAID, set GSATA3 6_7/IDE Controller to Enabled and set GSATA3 6_7/IDE
Ctrl Mode to RAID.
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
eXtreme Hard Drive (XHD)
ICH SATA Control Mode
SATA Port0-3 Native Mode
USB Controllers
USB Keyboard Function
USB Mouse Function
USB Storage Function
Onboard Audio
Onboard H/W LAN
Onboard USB 3.0 Controller
eSATA Controller
eSATA Ctrl Mode
GSATA3 6_7/IDE Controller
GSATA3 6_7/IDE Ctrl Mode
higf: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Integrated Peripherals
[Disabled]
[IDE]
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[IDE]
[Enabled]
[RAID]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 97 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix