Gigabyte G1.Guerrilla User Manual page 27

3/4/5) CPU_FAN/SYS_FAN/FAN1/FAN2/FAN3 (Fan Headers)
All fan headers on this motherboard are 4-pin and support fan speed control function. Most fan headers
possess a foolproof insertion design. When connecting a fan cable, be sure to connect it in the correct
orientation (the black connector wire is the ground wire). The speed control function requires the use of
a fan with fan speed control design. For optimum heat dissipation, it is recommended that a system fan
be installed inside the chassis.
• Be sure to connect fan cables to the fan headers to prevent your CPU and system from over-
heating. Overheating may result in damage to the CPU or the system may hang.
• These fan headers are not configuration jumper blocks. Do not place a jumper cap on the
headers.
6) HP_PWR (Heatsink LED Power Connector)
The power connector provides power to the LEDs on the North Bridge heatsink.
CPU_FAN:
Pin No. Definition
1
1
CPU_FAN
2
3
4
SYS_FAN/FAN1/FAN2/FAN3:
1 Pin No. Definition
SYS_FAN/FAN3
1
2
3
1
4
FAN1/FAN2
Pin No. Definition
1
2
1
- 27 -
GND
+12V
Sense
Speed Control
GND
+12V / Speed Control
Sense
Reserve
VCC
GND
Hardware Installation