Table of Contents
Advertisement
Installation and adjustment
Please install and adjust the machine according to the requirement of the mannual.
It is very important to your security and correct operating the machine.
Install the bottom plate
Insert the bottom plate to the pedestal from the front to
the back and the two fasteners to the opposite holes, then
install the bottom plate to the pedestal with the screw
by a cross screwdriver . See to the figure : (Please first
pull off the power plug from the receptacle
before installing.)
Adjust the Installation position
The washing machine away from wall should be overrun 20mm. The largest
allowable slope of the shank base of the machine is 2 .The slanting or rough
ground will result in unstable running or stoppage of the machine. Please adjust it
with following methods:
Confirm it's horizontal
Hang the lead line to check if it is horizontal.
Adjust the adjustable leg:
Please lift up the side of the leg slightly,
twist the adjustable leg, make sure to
keep the washing machine in balance.
Usage of the drain hose
Hang the drain hose to a suitable height.
The drain hose shall be higher than the
water in the tub avoid to siphon.(It doesn't
work normal as inleting water as drain)
Do not step on or press
the drain hose.
Screw
Front
Two fasteners
Back
Carpet
Bottom plate
High
Low
Adjustable
0.7m<H 1.2m
H
Advertisement
Table of Contents
