CONTENTS Names of the parts Meaning and description of the symbols Safety precautions Installation adjustment Preparation before washing Put in the laundries Usage of the detergent Use the operation buttons Close the top lid Finish washing Disposal after washing Trouble-shooting answer to question Packing list Specifications Packing list...
Trouble-shooting answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes.Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company.
Safety precautions The washing machine must be positioned so that Please plug the power plug on special the plug is accessible. Be sure to pull the plug off receptacle. Be sure to use three-pins and close the water faucet in following cases: power receptacle.
Before washing, please fold up the laundry as needed, then put the laundry into the inner tub, flat and neat. These fabrics are not washable: 1.Fabrics that deform when soaked in water; 2.Fabrics that shrink, discolor or go through other exterior changes when soaked in water; 3.Fabrics that lose original texture when soaked in water;...
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the inner cover component 1.Open the top lid of the washing machine. 2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove.
Page 7
D "WASH" button Press the WASH button to select wash " " procedure WASH "WASH " "+ - " Press the button, the light flashes then press SET from the STANDARD, HEAVY, CHILD, MEMORY programs 0-25mins . "+ - " Press SET button can change the process ,can not change time from the GENTLE and WOOL programs.
How to change the direction of the drain hose 1.Dismantle the rear cover of the washing machine. 3.Dismantle the drain outlet protecting cover at the other side, (the way is the same as the drain bushing),then install the drain 2.Put down the drain hose .Take off the drain hose bushing, as indicated in Figure 4.
Put in the laundries The capacity of washing of the machine refer to the largest weight of the standard laundries under dry condition that can be washed in one time. Laundries quantity in one washing cycle shall be lower than the standard capacity.
Connection between the water inlet hose and the washer 1.Do not take off the water absorption cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately. 2.Put the nut of the water inlet hose on the valve jointer. 3.Fasten the nut.