Adaptec SANbloc S50 Quick Install Manual page 5

Installing Your Adaptec Enclosure into a Rack
Ensure that you have these rackmount kit components:
1
• Front rails (1 left, 1 right)
• Rear rails, two different lengths (2 left, 2 right)
• 20 nuts (10 each of two different types)
• 4 small screws and 10 large screws
Secure the front rails to the front supports of the rack, using the screws
2
or nuts included in the kit. (Use the nuts if your rack does not have
threaded holes.)
)
Secure rear rail, using rail
length suitable for your rack
Select the right length of rails for your rack, then secure them to the
3
rear supports of the rack, as shown above. Then secure the front rails to
the rear rails.
Ensure that all the rail connections are tightened and secure.
3
Secure front rail
Rear support
Front
support
SANBloc S50 Quick Install Guide