Advertisement
When all SANbloc S50 enclosures are fully powered on, power on the
3
Snap Server.
Verifying that an Enclosure is Online
To verify that a SANbloc S50 enclosure is online:
Launch a Web browser and enter the Server name or IP address of the
1
Snap Server to which the SANbloc S50 enclosure is connected.
Click the Administration link and log in as admin with your
2
administrator password.
Navigate to the
3
The Disks/Units screen is a graphic representation of the RAID
configuration on your server. Your SANbloc S50 enclosure appears as a
12-disk drive chassis; disk drives installed in the enclosure appear as
online disk drives in correct physical position; unpopulated drive slots
appear as offline disk drives.
By default, the disk drives installed in the SANbloc S50 enclosure are
unassigned (not part of an array).
Registering Your SANbloc S50
To register your SANbloc S50, go to the
GuardianOS Administration Tool for your Snap Server, then follow the
online instructions.
If your server is already registered, re-registering the server will
Note
register the S50 as well.
SANBloc S50 Quick Install Guide
Storage > Disks/Units
screen.
Server > Registration
page of the
Advertisement
