Kenmore 4751 - 3.6 cu. ft. HE2 Use And Care Manual page 22

Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on
vacation or not using your washer for an extended period of time,
you should:
Unplug washer or disconnect power.
To transport the washer:
• Slightly open door to provide ventilation.
1. If washer will be moved during freezing weather, put in 1 qt
(1 L) of R.V.-type antifreeze in the drum. Run washer on a
Drain & Spin cycle.
2. Unplug the power cord.
3. Disconnect the drain hose from the drain system and attach
to rear panel clips.
4. Shut off both water faucets.
5. Disconnect the water inlet hoses from faucets, then drain the
hoses and clip them to the rear panel of the washer.
6. IMPORTANT: Call service. Do not reuse transport bolts.
Washer must be transported in the upright position. To avoid
suspension and structural damage, your machine must be
properly set up for relocation by a certified technician.
Reinstalling the washer
Turn off the water supply to the washer. This helps avoid
accidental flooding (due to a water pressure surge) while you 1.
are away.
2.
To winterize washer:
1. Put 1 qt (1 L) of R.V.-type antifreeze in the drum.
2. Run washer on a Drain & Spin cycle.
3. Unplug washer or disconnect power.
4. Shut off both water faucets.
5. Disconnect water inlet hoses from faucets and drain.
To use washer again:
1. Flush water pipes.
2. Reconnect water inlet hoses to faucets.
3. Turn on both water faucets.
Follow the "Installation Instructions" to locate, level and
connect the washer.
Run the washer through the Normal/Casual cycle to clean the
washer and remove the antifreeze, if used. Use only HE High
Efficiency detergent. Use 1/2of the manufacturer's
recommended amount for a medium-sized load.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or e_ectrical shock.
4=
5.
Plug in washer or reconnect power.
Run the washer through the Normal/Casual cycle. Use only
HE High Efficiency detergent. Use 1/2 of the manufacturer's
recommended amount for a medium-sized load.
22