Dell 1320c - Color Laser Printer User Manual page 32

Administrator E-Mail
Address
Asset Tag Number
EWS Settings Auto Refresh
Auto Refresh Interval
NOTE: The auto refresh feature is effective for the contents of the Top Frame, Printer Status page, Job List page, and Completed Jobs page.
Port Settings
Purpose:
To specify whether to enable or disable printing ports and management protocol features.
Values:
Ethernet Ethernet Auto
Settings
10Base-T
Half-Duplex
10Base-T
Full-Duplex
100Base-TX Half-
Duplex
100Base-TX Full-
Duplex
Current Ethernet Settings
MAC Address
Port LPD
Status
Port9100
FTP
E-Mail Alert
SNMP Agent
NOTE: The settings in the Port Settings page will be valid only when the printer is rebooted. When you change or configure the settings, click the
Restart printer to apply new settings button to apply new settings.
TCP/IP
Purpose:
To configure the IP address, subnet mask, and gateway address of the printer.
Values:
TCP/IP Host Name
Settings
IP Address AutoIP
Mode
DHCP
BOOTP
Specifies the contact address of the printer administrator and service center up to 63 alphanumeric characters.
Enter the asset tag number for the printer.
On Refreshes the contents of the status display pages automatically.
Off Does not refresh the status display pages automatically.
Sets the time interval for refreshing the contents of the status display pages automatically from 15 to 600
seconds.
Detects Ethernet transmission rate and the duplex settings automatically.
Selects 10Base-T Half-Duplex as the default value.
Selects 10Base-T Full-Duplex as the default value.
Selects 100Base-TX Half-Duplex as the default value.
Selects 100Base-TX Full-Duplex as the default value.
Displays the current settings of Ethernet.
Displays the printer's MAC address.
Select the check box to enable the LPD.
Select the check box to enable the Port9100.
Select the check box to enable the FTP port.
Select the check box to enable the E-Mail Alert feature.
Select the check box to enable the SNMP (Simple Network Management Protocol).
You can also configure the transport protocol to be used. UDP can be selected as the transport
protocol.
Specifies the host name up to 47 alphanumeric characters. The default name will remain valid if no entry is made.
Automatically sets the IP address.
Uses DHCP to set the IP address.
Uses BOOTP (BOOTstrap Protocol) to set the IP address.