Table of Contents
Advertisement
4076-0WJ
Top Cover Removal
1. Unplug the power cord and the interface cable from the back of
the printer.
2. Unlatch the auto sheet feed left cover by pushing it up from the
bottom, then slide it off the machine.
3. Turn the machine around to remove the rear cover. Remove the
screw and washer from the rear cover. Place a screwdriver in the
left slot [A] and push both latches latch down.
.
4. Pull the rear cover out until the latches clear the top cover, then
lift the cover off the base.
5. Turn the machine around to the front and pull the paper tray for-
ward.
6. Pull the top cover forward until it stops. Be sure the paper
release lever clears the slot in the top cover. The operator panel
cable is still connected, so carefully lift the cover off the base.
7. Set the cover down in front of the machine.
8. Pull the operator panel cable from the connector on the system
board.
NOTE: When you reinstall the top cover, pull out the exit tray to pre-
vent it from being trapped under the cover.
A
A
Repair Information
38
Advertisement
Table of Contents
