Table of Contents
Advertisement
4091-001
Carrier Transport Motor Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Disconnect the carrier transport motor connector from the
system board.
4. Remove the belt from the carrier transport motor pulley.
5. Remove the two screws securing the carrier transport motor to
the carrier frame and remove the motor. Note the routing of the
motor cable.
6. See the Note in the
DC/DC Converter Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Disconnect the DC/DC converter connector from the system
board.
4. Remove the screw that secures the DC/DC converter to the
carrier frame on the right side.
5. Push down on the latch at the left rear of the DC/DC converter
and slide it off the base.
Drive Train Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Unplug the paper feed motor assembly. Note the routing of the
motor cable.
5. Remove the two screws securing the drive train to the carrier
frame.
6. Push the drive train to the left and remove it from the carrier
frame.
"" on page
2-10.
Repair Information 4-5
Advertisement
Table of Contents
