Physical Interface Commands; Bridge Commands - Asus GigaX2024X - GigaX 2024X Switch User Manual

GigaX Series L2 Managed Switch User's Guide
5.3.2

Physical Interface Commands

[Admin] [Enable/Disable]
Displays the port admin status and allows user to turn the port on or off.
CLI command : l2 port admin <port number> <enable/disable>
[Mode] [Auto/10M-Half/10M-Full/100M-Half/100M-Full/1G-Full]
Displays the current speed and duplex mode of the port. The speed and
duplex mode can be automatically detected when auto-negotiation is enabled
on a port.
CLI command : l2 port autoneg <port number> <enable/disable>
CLI command : l2 port speed <port number> <10/100/1000>
CLI command : l2 port duplex <port number> <full/half>
[Flow Control] [Enable/Disable]
Displays the IEEE802.3x flow control setting of a port. Note that this flow
control is operating only in full duplex mode.
CLI command : l2 port flow <port number> <enable/disable>
[Reload]
Restores the previous port settings from the configuration file.
CLI command : l2 port retrieve
5.3.3

Bridge Commands

[Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]
Allows user to specify whether the switch participates the Spanning Tree
Protocol (STP/ RSTP).
CLI command : l2 stp start <stp / rstp>
CLI command : l2 stp stop
80