Part 3 - Basic Switch Setting For Management; Setting Up Through The Console Port; Table 3. Led Indicators - Asus GigaX2024X - GigaX 2024X Switch User Manual

GigaX Series L2 Managed Switch User's Guide
Table 3. LED Indicators
No.
1 System
2 Switch ports
[1] to [26]
3 RPS
4 Fan
3.3 Part 3 — Basic switch setting for
management
After completing the hardware connections, configure the basic settings for
your switch. You can manage the switch using the following methods:
•
Web interface: the switch has a set of pages to allow to you manage it
®
using Java
•
Command Line Interface: use console port to manage the switch.
3.3.1

Setting up through the console port

1. Use the supplied crossover RS-232 cable to connect to the console
port on the back of the switch. This port is a male DB-9 connector,
implemented as data terminal equipment (DTE) connection. Tighten
the retaining screws on the cable to secure it on the connector.
Connect the other end of the cable to a PC running terminal emulation
software. e.g. Hyper Terminal.
2. Use the supplied USB cable to connect to a PC. You have to install the
USB driver from the switch CD-ROM before the USB can work properly.
The USB drivers will simulate an additional COM port under Windows
ME/2K/XP OS.
20
LED
-enabled IE5.0 or higher version.
Description
Solid green indicates that the device is turned
on. If this light is off, check if the power
adapter if attached to the switch and plugged
into a power source.
Solid green indicates that the device can
communicate with the LAN, or flashing when
the device is sending or receiving data from
your LAN computer.
Solid green indicates that the device has
successfully installed an RPS module.
Solid green indicates that all fans work
properly