Setting The Channel Levels - Pioneer HTZ-830DV Owner's Manual

08 Surround sound setup

Setting the channel levels

You can set the relative channel levels from
your main listening position for each listening
mode, including all the Surround and
Advanced Surround modes.
If you used the Room Setup feature (page 21),
the channel levels for each listening mode will
already be set. However, you can still fine-
tune the levels here if you need to.
1 Press SURROUND or ADVANCED
repeatedly to select a listening mode.
60
En
STANDBY/ON
CD FM/AM L1/L2
DVD TUNER TV LINE
DISPLAY OPEN CLOSE
DVD MENU RETURN
ENTER
MUTE SOUND
MASTER
VOLUME
TV CONTROL
CH INPUT VOL
BASS MODE DIALOGUE VIRTUAL SB
AUTO SURROUND SURROUND ADVANCED
PROGRAM REPEAT RANDOM
AUDIO SUBTITLE ANGLE
HOME
ZOOM TOP MENU MENU
1 2 3
SYSTEM
CH LEVEL
SETUP TEST TONE TEST TONE
4 5 5 6
QUIET/ TIMER/
DIMMER MIDNIGHT CLOCK
7 8 9
FOLDER– FOLDER+
0
ENTER
CLR
ROOM SETUP
MAIN SUB
2 Switch the remote control to SUB,
then press TEST TONE to hear the test
tone.
The test tone is output in the following order
(from the speakers active in the current
listening mode):
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• RS – Right surround speaker
• LS – Left surround speaker
• SW – Subwoofer
3 Use the MASTER VOLUME +/– button
to adjust the volume to an appropriate
level.
Use the / (cursor up/down)
4
buttons to adjust the speaker levels in
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5 When you're done, press ENTER to exit
test tone setup.
• The speaker volume can be adjusted
while listening to any sound source you
want by pressing CH LEVEL and then
using the / (cursor up/down) buttons
to adjust the channel levels. After you're
finished with one channel, use the /
(cursor left/right) buttons to move to the
next.
• Since the subwoofer produces ultra-low
frequencies its sound may seem quieter
than it actually is.