Troubleshooting - Pacific hydrostar 1650 PSI Owner's Manual And Safety Instructions

troubleshooting

problem
Pressure Washer 1. Cord not connected.
will not start
2. No power at outlet.
3. GFCI circuit breaker tripped.
4. Internal damage or wear.
(Carbon brushes or switch, for example.)
Pressure Washer 1. GFCI circuit breaker tripped.
stops suddenly
2. Water leaking from housing.
Output pressure 1. Not enough water supply.
varies
2. Air in water supply.
3. Water Inlet Filter is clogged.
4. Extension Nozzle not
attached to Spray Gun.
5. Nozzle is clogged.
6. Nozzle has mineral build up.
7. Garden hose is too long.
8. Internal valves or seals may
be worn or sticking.
Trigger does Safety lock is still engaged.
not depress
Detergent will Incorrect detergent type.
not dispense
Performance Clogged with mineral deposits.
decreases over time
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power
supply before service.
SKU 69488
possible causes
For technical questions, please call 1-800-444-3353.
likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker.
If breaker is tripped, make sure circuit is right
capacity for tool and circuit has no other loads.
3. Press reset button on GFCI unit on cord.
4. Have a qualified technician service tool.
1. Press reset button on GFCI unit on cord.
2. SHOCK HAZARD! IMMEDIATELy
discontinue use. Have the unit repaired by
a qualified technician before further use.
1. Check water supply hose for kinks, leaks,
or blockage. Open faucet all the way.
2. Check that all connections are tight.
3. Remove Filter and clean.
4. Pressure is created by the Nozzle, not the
Spray Gun. Attach Extension Nozzle to unit.
5. Remove Nozzle and clean.
6. Remove Nozzle and clean with vinegar.
7. Recommended garden hose length is
20 to 50 feet, or 30 feet if using well water.
Shorten the length of the garden hose
if needed to increase pressure.
8. Have a qualified technician service tool.
Press in on the release button on the bottom of
the Spray Gun Handle to release the Safety Lock.
Check that the detergent is the recommended
type of detergent. Clean out dispenser and
replace with correct type if needed.
Clean unit with a de-mineralizing solution such
as vinegar or other aqueous acidic cleaner.
Page 15