HP LC2000r - NetServer - 128 MB RAM Configuration Manual page 2

Clock speed
No. of CPUs
BIOS version
CPU cache
RAM
No. of power supplies
Hot swap cages
Local storage
I/O slots:
Storage
Local
Physical drive location
Disk drives
Controller
SCSI Bus
Shared
Controller
Model
No. of controllers
Firmware
Driver
NetRAID Assistant
SPU I/O slot
SCSI ID
Channels
RAID level
Logical disks
Configuration
options:
Cabinet
Model
No. of cabinets
200 MHz.
2 – 4 (at least 2 are required)
1.00.09.CDOL or later
Any size
128 MB minimum. Must be HP.
3
May use for local storage; but not use for shared storage.
Internal or external, using any controller. Must use HP disks. See
Storage below.
P4 - P6 Shared storage controller
P3 or P4 - NetRAID local storage
P2 - Intra-cluster (Heartbeat) LAN
P1 - Client LAN
All others - Any other plug-in cards.
SPU internal drive bays, or HP external drive cabinet (e.g., HP Storage
System/8)
Must be HP
SPU embedded controller or any controller (any number, manufacturer
or driver) in any available I/O slot. Use P3 or P4 for NetRAID local
storage. See SPU I/O slots
Any HP cables that meet SCSI specifications and any SCSI bus speed
HP NetRAID D4943A
Use with HP Rack Storage/8 (D4902A) and HP Cluster Adapter only.
1-2
S.01.00
2.03
A.01.09
P4 - P6
6, 7
0 and 1 only
Do not use channel 2 for any purpose.
1, 5, 10 and 50 only
1 per RAID array
6 maximum per NetRAID adapter
Cluster mode on (cache write-through, no hot spare)
Ultra SCSI disabled
Termination: wide channel or automatic
Set any other options as you prefer
HP Rack Storage/8 D4902A
1-4
2
above.
Local