Gateway DX4320 Hardware Installation Manual page 22

Chapter 3: Configuring the New Drive
If your drive will be the last device on the SCSI cable or the only device
on the cable, as shown in Example A, make sure that a jumper is installed
on the SCSI termination jumper pins.
- OR -
If your drive will be in the middle of a SCSI chain, as shown in Example B,
remove the termination jumper. Make sure that the last SCSI device on
the cable has termination enabled.
4
Go to "Installing the New Drive" on page 21.
18 www.gateway.com