Gateway DX4320 Hardware Installation Manual page 37

If you are installing a Serial ATA drive, connect the signal cable to one of
the host adapter connectors on the system board. The Serial ATA drive does
not use the master/slave configuration, so connect the signal cable to either
Serial ATA host adapter.
4
Go to "To complete drive installation:" on page 33.
To complete drive installation:
1
Replace your computer case cover.
See the documentation that came with your computer for instructions on
replacing your computer case cover.
2
Reconnect the external cables, then plug in the power cord.
3
Turn on your computer.
4
If you replaced the master (boot) drive and the Windows
after restarting your computer, the hard drive installation procedure is
complete. Go to the next step.
- OR -
www.gateway.com
Connecting the drive cables
®
desktop appears
33