Table of Contents
Advertisement
3. If a Mini PCI card is not already installed, go to
a. Disconnect the Mini PCI card from any attached cables.
b. Release the Mini PCI card by spreading the metal securing tabs until the card pops up slightly.
c. Lift the Mini PCI card out of its connector.
4. Align the new Mini PCI card with the connector at a 45-degree angle, and press the Mini PCI card into the connector.
5. Connect the antenna cables from the Mini PCI card to the antenna connectors on the computer.
NOTICE:
The connectors are keyed for correct insertion; do not force the connections.
1 antenna cables (2)
2 antenna connectors on card (2)
6. Lower the Mini PCI card toward the inner tabs to approximately a 20-degree angle.
7. Continue lowering the Mini PCI card until it snaps into the inner tabs of the connector.
8. Ensure that the cables are positioned so that they will not be pinched when you replace the cover.
9. Replace the cover.
Hard Drive
NOTICE:
To prevent data loss, shut down your computer before removing the hard drive. Do not remove the hard drive while the computer is on, in
standby mode, or in hibernate mode.
NOTICE:
Hard drives are extremely fragile; even a slight bump can damage the drive.
CAUTION:
If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION:
Before working inside your computer, read the safety instructions in your Product Information Guide.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
1. Turn the computer over. Use a small screwdriver to loosen the two M3x5-mm hard drive screws.
step
4. If you are replacing a Mini PCI card, remove the existing card:
Advertisement
Table of Contents
