AT&T TL76108 - 5.8GHz Digital Corded/Cordless Answering System User Manual page 90

Appendix L
Troubleshooting
The batteries
will not hold a
charge.
I get noise,
static, or weak
signals even
when I'm near
the telephone
base.
• Other electronic products can cause interference with
your cordless phone. Try installing your phone as far
away from these types of electronic devices as possible:
television sets, VCRs, or other cordless telephones.
• If the cordless handset is in the charger and the charge
light does not come on, refer to The charge light is off
in this Troubleshooting guide.
• Charge the battery in the cordless handset for at least
16 hours. For optimum daily performance, return the
cordless handset to the charger when not in use.
• You may need to purchase a new battery. Please refer
to Handset battery installation & charging, page 10, in
this user's manual.
• If you subscribe to high-speed Internet service (Digital Sub-
scriber Line - DSL) through your telephone lines, you must
install a DSL filter between the telephone base and the
telephone wall jack (see pages 6-8). The filter will prevent
noise and caller ID problems caused by DSL interference.
Please contact your DSL service provider for more informa-
tion about DSL filters.
• You may be able to improve the performance of your
cordless phone by installing your new telephone base
as far as possible from any other existing cordless
telephone system that may already be installed.
• Other electronic products can cause interference to
your cordless phone. Try installing your phone as far
away from the following electronic devices as possible:
television sets, VCRs, or other cordless telephones.
87