Video Config - Panasonic BT-LH2170 Operating Instructions Manual

Main Menu
(continued)

VIDEO CONFIG

Submenu
GAMMA SELECT
* *
1 2
FILM GAMMA
COLOR TEMP.
SHARPNESS MODE
* *
5 6
SHARPNESS H
* *
5 6
SHARPNESS V
* *
5 6
*
1
When the SUB WINDOW function is used, changes are not reflected to the still image in the main window.
*
2
This menu is grayed out when the same item is assigned to GPI and [GPI CONTROL] is set to [ENABLE].
*
3
To select [USER 0 to 63]
A Press the rotary knob <PICTURE>. ([USER] changes to blue)
B Use the rotary knob <PICTURE> to select 0 to 63 and press the rotary knob <PICTURE>.
*
4
Selecting [VAR1], [VAR2] or [VAR3] engages the WB adjustment mode.(→page 29)
*
5
The following sharpness values
A VIDEO system input (VIDEO) (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/SHARPNESS V: 0)
B HD inputs other than A above (the factory defaults are SHARPNESS MODE: HIGH and SHARPNESS H/SHARPNESS V: 0).
C SD inputs other than A above (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/SHARPNESS V: 0).
are available and the settings for the selected input signal is displayed. During selection, adjustment status is displayed below the
[PICTURE] (picture adjusting) menu.
*
6
When HD signals are input via SDI1 and SD signals via SDI2 or SD signals via SDI1 and HD signals via SDI2 in TWO WINDOW or
PICTURE ASSIST function operation, changes in the sharpness setting from the menu affect only the left screen.
Setting
STANDARD Selects gamma curve.
FILM [STANDARD] Standard mode (power of 2.2)
STDIO/PST [FILM]
CINEMA [STDIO/PST] Color emphasis mode (power of 2.35)
[CINEMA]
• When [FILM] is selected, the
VARICAM Selects type of FILM gamma mode.
OTHER [VARICAM] For VARICAM use
(Gumma curve image)
Selects color temperature.
USER 0 to 63 *
3
D93 [USER 0 to 63] Adjustable settings 0 to 63
D65
D56 [D93]
VAR1 [D65]
VAR2 [D56]
VAR3 [VAR1] WB (White Balance) adjustment mode
[VAR2] WB (White Balance) adjustment mode
[VAR3] WB (White Balance) adjustment mode
HIGH Selects the width of outline correction edge.
LOW [HIGH] Narrow edge
[LOW]
0 to 30 Sets horizontal outline correction. The item display moves to the lower part of the
screen during adjustment.
0 to 30 Sets vertical outline correction. The item display moves to the lower part of the
screen during adjustment.
Description
Film mode
CINEMA mode (power of 2.6)
[OTHER] For other cameras
OTHER
Video Gamma
Input Level
(equivalent to a color temperature range of 3,000 K to 9,300 K)
Equivalent to a color temperature of 9,300 K
Equivalent to a color temperature of 6,500K
Equivalent to a color temperature of 5,600 K
Wide edge
The underlined values are factory defaults.
mark is displayed for the operating status.
VARICAM
*
4
*
4
*
4
(Continued on next page)
27