Video Config - Panasonic BT-LH900 Operating Instructions Manual

MAIN MENU

VIDEO CONFIG

Item Setting
GAMMA SELECT GPI For setting the gamma mode.
NORMAL GPI:
FILM
NORMAL: The normal gamma mode is
FILM:
COLOR TEMP. USER For setting the color temperature.
D93 USER: Any setting from 0 to 63 (equivalent
D65
D56
D93:
D65:
D56:
<Note>
The color temperature can be set for each
gamma mode (NORMAL, FILM).
SHARPNESS HIGH For setting the image sharpness.
MODE LOW HIGH: The images are accentuated with
LOW: The images are accentuated with
<Note>
The sharpness can be set for VIDEO and
all other input channels.
SHARPNESS H 0 For setting the image sharpness in the
:
horizontal direction.
2
This item enables two settings, one for the
:
VIDEO input signals and one for other
30
signals, to be stored in the memory.
<Notes>
≥ While this item's setting is selected, the
≥ The sharpness can be set for VIDEO and
SHARPNESS V 0 For setting the image sharpness in the
:
vertical direction.
2
This item enables two settings, one for the
:
VIDEO input signals and one for other
30
signals, to be stored in the memory.
<Notes>
≥ While this item's setting is selected, the
≥ The sharpness can be set for VIDEO and
The underlined setting indicates the factory setting mode.
18
Description
This is the GPI setting.
details, refer to "REMOTE
specifications" (page 22).
established.
The film mode that supports the
Varicam digital cine camera is
established.
to a color temperature range from
3000 K to 9300 K) can be
established.
This is equivalent to a color
temperature of 9300 K.
This is equivalent to a color
temperature of 6500 K.
This is equivalent to a color
temperature of 5600 K.
fine edges.
thick edges.
only information displayed on the screen
is this item which appears at the bottom
left regardless of the MENU POSI setting
selected on the OSD screen.
all other input channels.
only information displayed on the screen
is this item which appears at the bottom
left regardless of the MENU POSI setting
selected on the OSD screen.
all other input channels.
Item Setting
I-P MODE MODE2
For MODE1
MONO GPI
OFF
ON
SD ASPECT GPI
16:9
4:3
Description
For switching the IP conversion mode.
MODE2: Movement compensation mode
MODE1: Normal mode
<Note>
This setting takes effect when progressive
signals (1080/30P, 1080/25P, 1080/24P,
720/60P or 480/60P) are input.
For selecting monochrome images.
GPI: This is the GPI setting. For details,
refer to "Concerning the REMOTE
specifications" (page 22).
OFF: Normal images
ON: Monochrome images
<Notes>
≥ No adjustments are possible when RGB
signals are input.
≥ When ON has been selected as this
item's setting, the setting for the
CHROMA image control is fixed at 0.
When the setting is returned to OFF, the
CHROMA setting prior to the change is
restored.
For setting the aspect ratio of the SD
signals.
GPI : This is the GPI setting. For details,
refer to "REMOTE specifications"
(page 22).
16:9 : The images are displayed with a
16:9 aspect ratio.
4:3 : The images are displayed with a 4:3
aspect ratio.