Gigabit Ethernet Rj-45 Connections On The Npe-G1 And Npe-G2 - Cisco 7206VXR - VPN Bundle Router Configuration Manual

Chapter 3 Installing a Cisco 7200 VXR Router
Note The mode-conditioning patch cord is required to comply with IEEE standards. The IEEE found that link
distances could not be met with certain types of fiber-optic cable cores. The solution is to launch light
from the laser at a precise offset from the center, which is accomplished by using the mode-conditioning
patch cord. At the output of the patch cord, the WS-G5486 or GBIC-LX/LH is compliant with the IEEE
802.3z standard for 1000BASELX.
A mode-conditioning patch cord can be used with the WS-G5486= or GBIC-LX/LH= to allow reliable
laser transmission between the single-mode laser source on the GBIC and a multimode fiber-optic cable.
We strongly recommend cleaning optical fiber connections before attaching cables to equipment. See the
Note
"Fiber-Optic Cleaning Information" section on page 5-10

Gigabit Ethernet RJ-45 Connections on the NPE-G1 and NPE-G2

The NPE-G1 and NPE-G2 RJ-45 ports support 10BASET, 100BASETX, and 1000BASET and
1000BASEX protocols and the ports are compliant with IEEE 802.3, IEEE 802.3u, and IEEE 802.1q
standards.
The RJ-45 ports support standard straight-through and crossover Category 5 UTP cables with RJ-45
connectors. (See
these cables are available commercially.
Figure 3-20
port.
Table 3-10
Pin
1
2
3
4
5
6
7
8
1. Tx Data = Transmit Data
2. Rx Data = Receive Data
With reference to the RJ-45 pinouts in
Note
used for the unused Category 5 UTP cable pairs 4/5 and 7/8. Common-mode line termination reduces
electromagnetic interference (EMI).
Depending on your RJ-45 interface cabling requirements, use the pinouts shown in
Figure 3-24
OL-5013-09
Figure 3-23 and Figure
shows an RJ-45 port and connector.
NPE-G1 and NPE-G2 RJ-45 Port Pinouts
10/100 Signal
1
Tx Data+
Tx Data–
2
Rx Data+
N/C
N/C
Rx Data–
N/C
N/C
for straight-through and crossover twisted-pair cable connections.
Connecting I/O Controller, NPE-G1, or NPE-G2 Cables
for information.
3-24.) Cisco Systems does not supply Category 5 UTP cables;
Table 3-10 lists the pinouts and signals for the RJ-45
Gigabit Ethernet Signal
Tx A+
Tx A–
Rx B+
Tx C+
Tx C–
Rx B–
Rx D+
Rx D-
Table 3-10, proper common-mode line terminations should be
Cisco 7200 VXR Installation and Configuration Guide
Figure 3-23 and
3-29