Tools And Parts Required - Cisco 7206VXR - VPN Bundle Router Configuration Manual

Preparing for Installation
Before installing your Cisco 7200 VXR router, you should consider the power and cabling requirements
that must be in place at your installation site, the equipment you need to install the router, and the
environmental conditions your installation site must meet to maintain normal operation. This chapter
guides you through the process of preparing for your router installation.
The chapter contains the following sections:
•
•
•
•
•
•
•
•
Before you install, operate, or service the system, read the
Warning
Information for Cisco 7200 Series Routers
information you should know before working with the system. Statement 200

Tools and Parts Required

Your Cisco 7200 VXR chassis is fully assembled at the factory; no assembly is required. However, you
need the following tools and equipment to install the chassis and the rack-mount and cable-management
kit:
•
•
•
•
•
The rack-mount and cable-management kit includes the following parts:
•
OL-5013-09
Tools and Parts Required, page 2-1
Electrical Equipment Guidelines, page 2-2
Preventing Electrostatic Discharge Damage, page 2-2
Site Requirement Guidelines, page 2-3
Initial Configuration Information, page 2-9
Cisco 7200 VXR Router Installation Checklist, page 2-10
Checking the Shipping Container Contents, page 2-12
Site Log, page 2-13
Number 2 Phillips screwdriver
A 3/16-inch flat-blade screwdriver
A 1/4-inch flat-blade screwdriver
Tape measure (optional)
Level (optional)
Two rack-mount brackets for mounting the chassis in the rack
C H A P T E R
Regulatory Compliance and Safety
publication. This document provides important safety
Cisco 7200 VXR Installation and Configuration Guide
2
2-1