Removing the Palmrest Module/Upper Cover
1. Perform the
"External Module Disassembly
2. Perform the
"Removing the
3. Open the connector latch for the click button (rubber dome) cable (1), and then disconnect
the cable (2).
Figure 1-29. Click Button (Rubber Dome) Cable
4. Open the connector latches for both the fingerprint board and touchpad cables (1), and
then disconnect the cables (2).
Fingerprint
board cable
Figure 1-30. Fingerprint Board and Touchpad Cables
Machine Maintenance
Process" procedure described on page 3-8.
Keyboard" procedure described on the preceding section.
Touchpad
cable
0
3-25