Adding And Configuring Nics In A Team; Nas 4000S And 9000S Administration Guide - HP StorageWorks 4000s - NAS Administration Manual

Adding and Configuring NICs in a Team

Before a NIC is teamed, verify the following:
Note:
set before teaming.
To team the NICs:
1. Open the HP Network Teaming utility. The Network Teaming and Configuration
Figure 16: HP Network Teaming Properties dialog box
2. Highlight the NICs to team.
3. Click the Team button. The Teaming Controls tab of the Properties dialog box is

NAS 4000s and 9000s Administration Guide

The NICs must be on the same network.
The NICs must be DHCP enabled and the DNS server address must be left blank.
The teaming utility becomes unstable if static IP addresses, subnets, and DNS addresses are
Duplex and speed settings must be set to use the default values.
Properties dialog box is displayed. The type of NIC and the slot and port used is shown.
displayed.
Basic Administrative Procedures and Setup Completion
41