Using The Smh With The Insight Providers; Introduction To Smh; Change Data Source; Auto Refresh - HP ProLiant BL30p User Manual

Using the SMH with the Insight Providers

Introduction to SMH

The layout of the SMH remains the same as the last version; however, there are changes on subpages.
The content and pertinent information are similar, but the layout has been redesigned to be more user-
friendly.

Change Data Source

The SMH now enables data collected from the Insight Providers or SNMP agents. After the Insight
Providers are installed, SMH defaults to WBEM as the data source.
To change this setting:
Log in to the SMH, and then click Settings > Select SMH Data Source > Select.
1.
Click the WBEM or SNMP radio button.
2.
Click Select.
3.
Log out of the SMH.
4.
Log back in to the SMH.
5.

Auto Refresh

The Auto Refresh option is a new feature. When the SMH uses the SNMP data source, each page must
be manually refreshed to retrieve the latest information. When using WBEM as the data source, the user
can manually refresh the information or set an Auto Refresh interval to get updates.
To enable WBEM Auto Refresh and to set the Refresh interval:
Click Settings>Auto Refresh>Configure Page Refresh Settings.
1.
Select a refresh interval between 5 seconds and 30 minutes.
2.
Click the Auto Refresh radio button.
3.
After WBEM Auto Refresh is enabled, the browser refreshes the pages at the specified interval.

Threshold settings

The SMH enables the user to set thresholds on CPU utilization and Disk utilization.
To create threshold settings:
Click Tasks (Tab) > Server Configuration > Threshold Information.
1.
Enter values for processors and disks. If there are many processors or disks, the user can set them all
2.
at once using the global options.
Using the SMH with the Insight Providers 16