Windows Server 2008 Firewall Configuration; Firewall Configuration Introduction; Firewall Configuration - HP ProLiant BL30p User Manual

Windows Server 2008 Firewall configuration

Firewall configuration introduction

This section describes a configuration method for enabling direct remote WMI access on a server running
the Windows Server® 2008 Firewall.
There are many methods to establish remote communication with WMI. Locally privileged programs can
establish communication with WMI locally and serve up a private or standardized remote management
interface. The SMH and Windows Remote Management (an implementation of WS Management) are
examples.
This documentation does not apply to these or other indirect methods of WMI related communication,
only to direct remote connections to WMI. Firewall configurations for indirect WMI communication
methods are independent of establishing a direct remote connection to WMI.
In addition to being used to set up the firewall, some user privileges are used in creating direct remote
WMI access. For example, when the user is not an Administrator, some privileges might not exist by
default.
For more information, see Security requirements for the Insight Providers (on page 10) and the MSDN
article Securing a Remote WMI Connection
us/library/aa393266.aspx).

Firewall configuration

You can establish direct remote WMI access on a computer running the Windows Server® 2008
Firewall, but the default configuration does not provide for this access. However, by using the built-in
firewall rules, you can enable remote WMI access with two commands.
Locally execute the following commands on the Windows Server® 2008 machine that is providing WMI
access (on a computer running the Insight Providers on Windows Server® 2008):
netsh advfirewall firewall set rule group="Windows Management
Instrumentation (WMI)" new enable=yes
Output:
The commands enable all firewall rules contained in the specified firewall group. If the command output
does not confirm that the rules were updated, check that the group name and each word in the command
are correct. The following is an example of a group name with spacing highlighted in bold:
"Windows<SPACE>Management<SPACE>Instrumentation<SPACE>(WMI)"
This first command is equivalent to selecting the Windows Management Instrumentation (WMI) checkbox
in the Control Panel > Windows Firewall > Settings > Exceptions tab.
An additional firewall rule is needed to enable a remote user to establish a WMI session. It can be
enabled with the following command:
Updated 4 rule(s).
Ok.
(http://msdn2.microsoft.com/en-
Windows Server 2008 Firewall configuration 22