Eyelet Stitching - Brother LB6770 PRW Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/
64 and 3/16 inch).
Stitch Name Pattern
62
Sewing eyelets, for example, on
Eyelet stitch
belts
CAUTION
● Be sure to turn off the main power before replacing the pressor foot. Otherwise, injuries may
occur if (Start/stop button) is accidentally pressed and the machine starts sewing.
a Attach monogramming foot "N".
• For details on replacing the presser foot, refer
to "Replacing the presser foot" (page 43).
62
b Select stitch .
• For details, refer to "Selecting stitching"
(page 49).
c Adjust either the stitch width or the stitch
length to select the desired eyelet size.
• For details, refer to "Adjusting the stitch
width" (page 57) and "Adjusting the stitch
length" (page 59).
mm 6mm
108
Application
d
e
f
5mm
Stitch Width Stitch Length
[mm (inch)]
Auto Manual Auto
7.0, 6.0 or
7.0 5.0 7.0
(1/4) (1/4, 15/64 (1/4)
or 3/16)
Lower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
Start sewing.
Once sewing is completed, the sewing
machine automatically sews reinforcement
stitches, then stops.
Use the eyelet punch to cut a hole in the
center of the eyelet.
When using the eyelet punch, place thick paper
or some other protective sheet under the fabric
before punching the hole in the fabric.
Memo
If thin thread is used, the stitching may be
too open. If this occurs, sew the eyelet twice
before removing the fabric, one on top of the
other.
Presser
[mm (inch)]
Foot
Manual
7.0, 6.0 or
5.0
N
(1/4, 15/64
or 3/16)