Setting The Stitch; Adjusting The Stitch Width - Brother LB6770 PRW Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Setting the Stitch

This machine is preset with the default settings for the stitch width and stitch length for each stitch. However,
you can change any of the settings by pressing
section.
Note
Settings for some stitches cannot be changed. For details, refer to "Stitch Setting Chart" (page 70).
Stitch settings return to their defaults if they are changed, when the machine is turned off or a different
stitch is selected before the stitch setting is saved. If you want to save settings, refer to "Saving stitch
settings" (page 64).

Adjusting the stitch width

The stitch width (zigzag width) can be adjusted to
make the stitch wider or narrower.
Each press of
Each press of
makes the zigzag stitch narrower.
makes the zigzag stitch wider.
in the screen, then follow the procedure described in this
Memo
means the setting cannot be adjusted.
If the straight stitch (left needle position or triple
stretch stitch) was selected, changing the stitch
width changes the needle position. Increasing
the width
reducing the width
left. For details, refer to "Changing the needle
position" (page 79).
Press
If the foot controller is connected, the
sewing speed controller can be used to
adjust the zigzag width. For details, refer to
"Adjusting stitch width using the sewing
speed controller" (page 58).
CAUTION
After adjusting the stitch width, slowly
turn the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the
needle may bend or break.
moves the needle to the right;
moves the needle to the
to return the setting to its default.

Setting the Stitch 57

2