Needle And Presser Foot Section; Right-Side/Rear View - Brother LB6770 PRW Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Needle and presser foot
section
a Buttonhole lever (page 86)
Lower the buttonhole lever when sewing buttonholes
and bar tacks.
b Thread guide disk (page 34)
Pass the thread through the thread guide disk when
using the needle threader to thread the needle.
c Needle bar thread guide (page 34)
Pass the upper thread through the needle bar thread
guide.
d Needle plate (page 67)
The needle plate is marked with guides for sewing
straight seams.
e Needle plate cover (page 152)
Remove the needle plate cover to clean the bobbin case
and race.
f Bobbin cover/bobbin case (page 28)
Remove the bobbin cover, and then insert the bobbin
into the bobbin case.
g Feed dogs (page 88)
The feed dogs feed the fabric in the sewing direction.
h Presser foot (page 43, 50)
The presser foot applies pressure consistently on the
fabric as the sewing takes place. Attach the appropriate
presser foot for the selected stitching.
i Presser foot holder (page 45)
The presser foot is installed onto the presser foot holder.

Right-side/rear view

a Handle
Carry the sewing machine by its handle when
transporting the machine.
b Handwheel (page 50)
Turn the handwheel toward you (counterclockwise) to
raise and lower the needle to sew one stitch.
c Embroidery card slot (page 138)
Insert the embroidery card.
d Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the sewing
machine is being used.
e Main power switch (page 17)
Use the main power switch to turn the sewing machine
on and off.
f Foot controller jack (page 52)
Insert the plug on the end of the foot controller cable
into the foot controller jack.
g Power supply jack (page 17)
Insert the plug on the power supply cord into the power
supply jack.
h Drop feed lever (page 88)
Use the drop feed lever to lower the feed dogs.
Memo
Refer to pages 10 through 13 while you are
learning to use your machine.
11