After A Windows 2000 Shutdown; Wake-On-Ring (Wor) Does Not Function On Apm-Supported Thinkpad Model Running Windows 2000; When The Computer Wakes Up From Standby By Wake-On-Ring, Wake-On; Lan , Or Rtc Resume The Lcd Display Does Not Turn On - Lenovo ThinkPad 380E Setup Manual

1.5 Wake on LAN
function after a Windows 2000 shutdown
Models: ThinkPad model 390
Issue: After Windows 2000 shuts down, the system cannot not wakeup from power
off state by Magic Packet(IBM WOL).
Cause: This is a hardware limitation.
Resolution: After Windows 2000 properly shuts down with IBM WOL enabled, you must
manually power on and off your computer in order to get IBM WOL
functioning.
1.6 Wake-On-Ring (WOR) does not function on APM -supported ThinkPad
model running Windows 2000
Models: ThinkPad models 760XD, 765D, and 770 with internal modems
Issue: Cannot wake up the computer from an incoming call when in Standby mode.
Cause: On APM -supported ThinkPad models with an internal modem, WOR is not
enabled by default through the BIOS settings. This capability can be enabled
by installing the ThinkPad Configuration Utility.
Resolution: To enable WOR on your APM-supported ThinkPad system, follow these
instructions:
1.7 When the computer wakes up from Standby by Wake-On-Ring, Wake-
On-LAN , or RTC resume the LCD display does not turn on
Models: All ACPI-supported ThinkPad models
Issue:

When the computer wakes up from Standby by Wake-On-Ring, Wake-On-

LAN, or RTC resume, the LCD display does not turn on.
Cause: This is by design of Windows 2000 for an unattended wake up.
Resolution:
After the system wakes up from WOR, WOL , or RTC press the keyboard or
move the pointing device to turn on the LCD display.
1.8 The LCD monitor does not turn on when the computer returns from
Standby
Models: ThinkPad model 390
Issue: When the computer resumes from Standby, the LCD monitor might not turn
on.
Cause: This is a current design limitation of the system BIOS.
Resolution: Press any key or move the pointer device to turn on the LCD monitor.
1.9 After computer returns from Hibernation mode , both the CRT and LCD
monitor are active -- cannot keep the previous display condition.
Models: ThinkPad model 240
®
from Power Off state (IBM WOL feature) does not
1. Install the ThinkPad Configuration Utility for Windows 2000.
2. After installing the utility, click: Start
Panel.
3. Double-click the Power Options applet. After the "Power Options
Properties" window opens, click the "Suspend/Resume Options"
tab.
4. Verify the "Resume on incoming call" is checked. If not, click this
option.
5. Click [Apply].
? ?
Settings Control