Installing Thinkpad Acp Modem Update For Windows 2000 (Thinkpad 600, 600E, And 770 Series Models) - Lenovo ThinkPad 380E Setup Manual

Installing ThinkPad ACP Modem update for Windows 2000 (ThinkPad 600, 600E,
and 770 Series models)
The internal ACP Modem is included on the Windows 2000 Professional CD and will be
automatically installed by the Windows 2000 Setup program. This native built-in driver
provides the "standard" modem support on your ThinkPad. Under most circumstances, the
user will not need to update this driver. However, if you need to run an application program
that requires the use of wake-up (Wake-On Ring) capability from an incoming modem call
while the system is in Standby mode, the standard native driver will not support this. For
example, Windows 2000 Professional provides the capability to send and receive fax to/from
your computer. By using the Wake-On-Ring feature, you can receive an incoming FAX
when the computer is in Standby mode when this updated device driver is installed. In order
for your ThinkPad to support WOR, you will need to install this updated ACP Modem driver.
To install the ThinkPad ACP Modem driver on your ThinkPad, follow the instructions
provided below:
1. Boot and logon to Windows 2000 Professional with an Administrator user account.
2. Click: Start ? Settings ? Control Panel
3. Double-click the System applet, then click the 'Hardware' tab.
4. Click on [Device Manager...].
5. Click on [+] to the left of "IBM Digital Signal Processors" and open the Properties
window for the "ThinkPad Digital Signal Processor".
6. Click on the 'Driver' tab, then click [Update Driver...]. Click [Next]. Select the "Display a
list of the known...." option then click [Next].
7. Click on "Have Disk..." and at the "Copy manufacture's file from:" box, type in the
location of where the drivers are located. Click [OK].
8. Select the "ThinkPad Digital Signal Processor" device and click [Next].
9. Click [Next] to start the installation.
10. The "Digital Signature Not Found" window will appear on your screen. Click [Yes] to
any of these messages to continue the installation.
11.
After the files are copied to your system and Windows has finished installing the device,
click on [Finish].
12. Restart your computer when prompted to complete the upgrade.
To enable Wake-On-Ring (WOR) for the ThinkPad ACP Modem on AC PI-supported
ThinkPad models, follow these instructions:
1 Turn on your computer, and then logon to Windows 2000 Professional with an
Administrator user account.
2 Click: Start ? Settings ? Control Panel
3 Double-click the System applet, then click the 'Hardware' tab.
4 Click [Device Manager...].
5 Click on [+] to the left of "Modems" and open the Properties window for the "ThinkPad
Modem".
6 Click 'Power Management' tab. Verify that the "Allow this device to bring the computer
out of Standby" option is checked. If not, click this option.
7 Click [OK] when finished.
To enable Wake-On-Ring (WOR) for the ThinkPad ACP Modem on APM-supported
ThinkPad models, refer to item 1.6 of the "Windows 2000 Hints and Tips" section.