Lenovo ThinkPad 380E Setup Manual page 36

9. Click [Yes] to continue.
10. To install DVDExpress in the default folder, click [Next].
11. The Setup program will begin copying files to your system.
12. After all files are copied to your computer, click [Finish] to automatically restart your
computer for the changes to take effect.
When your computer restarts, the DVDExpress DVD player is installed and ready to be
13.
used for Windows 2000.
For the best results while playing back DVDs under Windows 2000, the transfer mode for the
DVD-ROM drive should be to be set to DMA mode. To enable DMA mode for your
computer's DVD -ROM drive, following these instructions below:
1. Verify that the DVD -ROM drive is installed on your ThinkPad computer.
2. Click: Start ? Settings ? Control Panel.
3. Double-click the System applet. After the "System Properties" window opens, click
the "Hardware" tab.
4. Click [Device Manager...]. Expand the [+] next to "IDE ATA/ATAPI controllers".
5. Highlight the "Secondary IDE Channel" device and double-click it to open its
Properties window.
6. Click the "Advanced Settings" tab.
7. Under "Device 0", locate the "Transfer Mode:" list box; and then select the "DMA if
available".
8. Click [OK].
9. Click [Yes] to allow the operating system to automatically restart your computer.
When Windows restarts your computer, your DVD-ROM drive will run in DMA
10.
mode.